Installation Instructions Mazda Miata 1990-2003
(Patent Pending)
      Included Materials:
    • 1 Acrylic Piece
    • 2 Metal Brackets (Left & Right)
    • 4 Metric Hex Bolts
    • 8 Washers
    • 1 Short Arm Hex Tool
    • Installation Instructions

      Additional Tools required:
    • 10mm socket wrench
    • Phillips screw driver (1999+ models)

    Windjammer Sport installation can't get any easier than this! It will take only a few minutes, following these 5 easy steps.

    Step 1:
    With the convertible top down, and the seats forward, remove the 2 factory Tenax bolts†, (Phillips screws on 1999+ models) one on each seat belt tower. Factory wind blocker must be removed prior to Windjammer Sport installation on 1999+ models.

    Step 2:
    Install the brackets to the seat belt towers using the same factory bolt previously removed. Do not tighten this bolt yet (this will allow the brackets to float a little).

    Step 3:
    With the brackets in place, align the acrylic piece to the mounting holes on the brackets with the Windjammer Sport logo to the passenger side. (Be careful not to scratch the acrylic piece during the installation process.)

    Step 4:
    Insert one Hex bolt and two washers per slot, one washer on each side of the acrylic. Position the acrylic piece as low as possible and tighten all four Hex bolts.

    Step 5:
    After the four Hex bolts are fully secure, tighten both factory Tenax bolts on the seat belt towers.


    Notes:

    • After installation, take your vehicle for a low speed test-drive prior to using it on the highway.

    • To use the soft-top boot, loosen the four (4) Hex bolts and raise the acrylic piece to allow the boot cover to slide underneath the acrylic. Then, lower the acrylic, secure into position and repeat Step 5.

    • We recommend you tighten your Windjammer Sport assembly hardware periodically.



    Windjammer Sport and the Windjammer Sport Logo
    are trademarks of Ryan-Performance.
    All other names are property of their respective owners.


    P/N 70-0001-00-11
    Graphics By: Dan Kim
    Copyright © 2002-2003. All rights reserved.


    †Tenax Bolt –Bolt used to attach the factory soft-top boot.

    Back




      Step 1-2


      Step 3


      Step 4-5