Rear Fog Light
Installation Instructions Mazda Miata 1990-2003
      Included Hardware:
    • 1 Light Fixture
    • 1 Metal Bracket
    • 2 Machine Screws
    • 1 Rubber Bumper
    • 1 Scotchlok tap*
    • Installation Instructions

      Additional Tools required:
    • Wire cutters/splicers
    • Phillips screw driver

    Ryan-Performance Rear Fog Light installation can't get any easier than this! It will take only a few minutes, following these 5 easy steps.

    Step 1:
    As a safety precaution, always disconnect the battery positive terminal when making electrical connections.

    Step 2:
    Step 2: Using the machine screws provided, install the Rear Fog/Rain Light into the back of the rear bumper. (Tip1: European regulations stipulate that the Rear Fog/Rain Light must be place below and offset from the vehicles rear brake lights, refer to picture below.)

    Step 3:
    Connect the black wire to any metal bolt on the body of the car. This will be your ground connection.

    Step 4:
    With the provided midline tab to connect the “Red” to the power source. (Tip2: A common connection point could be one of the rear side markers that can be reached from underneath the car.)

    Step 5:
    Connect the battery positive terminal, test your connection, align and adjust your light then tell all your friends you are done!


    Notes:

    • The included rubber bumper could help eliminate possible vibration or scratches to the body of the car.

    • After installation, take your vehicle for a low speed test-drive prior to go into the open road.

    • On 1999+ models, in lie of a rear side marker light, power must be drawn from the rear parking light.



    Ryan-Performance's Logo
    ia s trademarks of Ryan-Performance.
    All other names are property of their respective owners.


    P/N 70-0002-00-03
    Copyright © 2002-2003. All rights reserved.


    †Scotchlok tap –- Also known as midline tab connector.

    Back